单臂路由配置命令ensp(单臂路由配置实验总结)

[db:作者]

实验拓扑图
1.配置电脑的IP地址:
PC1
PC2
PC3
2.配置交换机:创建VLAN 10 20 30，将连接到PC的接口分配给对应的VLAN，更改接口模式，将交换机GE0/0/1更改为trunk，并允许其通过VLAN 10 20 30。配置如下:
系统视图
[华为]sysname S1
[S1]vlan批10 20 30 //创建VLAN 10 20 30
[S1]接口千兆以太网0/0/2
[S1千兆以太网0/0/2]端口链路型接入
[S1千兆以太网0/0/2]端口默认vlan 10
[S1-千兆以太网0/0/2]接口千兆以太网0/0/3
[S1千兆以太网0/0/3]端口链路型接入
[S1千兆以太网0/0/3]端口默认vlan 20
[S1-千兆以太网0/0/3]接口千兆以太网0/0/4
[S1千兆以太网0/0/4]端口链路型接入
[S1千兆以太网0/0/4]端口默认vlan 30
[S1]接口千兆以太网0/0/1
[S1千兆以太网0/0/1]端口链路型中继
[S1千兆以太网0/0/1]端口中继允许通过所有vlan
AR1配置:
系统视图
[华为]sysname AR1
[AR1]接口千兆以太网0/0/0.1
[AR1-千兆以太网0/0/0.1]ip地址192.168.1.254 24
[ar1-千兆以太网0/0/0.1] dot1q终端vid10//vlan10标签
[AR1-千兆以太网0/0/0.1]arp广播使能
[AR1-千兆以太网0/0/0.1]接口千兆以太网0/0/0.2
[AR1-千兆以太网0/0/0.2]ip地址192.168.2.254 24
[ar1-千兆以太网0/0/0.2] dot1q终端vid20//vlan20标签
[AR1-千兆以太网0/0/0.2]arp广播使能
[AR1-千兆以太网0/0/0.2]接口千兆以太网0/0/0.3
[AR1-千兆以太网0/0/0.3]ip地址192.168.3.254 24
[ar1-千兆以太网0/0/0.3] dot1q终端vid 30//标签VLAN30
[AR1-千兆以太网0/0/0.3]arp广播使能
测试:
PC1
PC1
PC1
PC2
PC2